Soldered up all of stepper motor controller. Used toaster oven reflow for the controller IC, not necessary spacing on pads very comfortable. Have not tested yet. Will test after oatmeal.
The motherboard I was getting ready to solder and The Dangler stepped in and asked me if he could do it. He wanted to show off for the lady in the room. (He stated that out loud.) The pictures shown here are his workshop and the finished product of the ICs on the motherboard. Very, very, very good work. THe final product of his soldering is pictured here also.
These boards are super well documented. I would like to make that clear. The circuit is easy to understand, and easy to assemble. I never looked at the documentation to solder up the stepper controller. I think that is a testament to the great documentation done by the RepRap team.
No comments:
Post a Comment